What are the ways to reduce injection mold maintenance?

1. Strengthen scientific injection Helmet Mould knowledge training and try not to damage the mold during production. Improper parameters such as low pressure protection settings, clamping speed, clamping force, injection speed, holding pressure, and mold temperature will greatly damage the mold.
2. Production control. Similar to the hot runner plug iron and PIN pin in the table that damage the mold should be avoided as much as possible.
3. Fetal problems should be avoided. The design and manufacturing process of plastic mold processing is "pregnancy", and there can be no problems at this time, otherwise maintenance is unavoidable. For example, the design and material of the seven major systems of the mold will not be discussed one by one.

4. Mold maintenance. The first-level and second-level maintenance in the usual production and the third-level maintenance of the mold repair department should be solid and in place. Any drawing dust should be avoided, and the spring breakage/thimble card/shovel chicken thorn should be avoided.
5. Standardization and inventory of wearing parts. Thimble / spring / cylinder / guide post / guide sleeve, etc. should be as uniform as possible, and stocked.
6. Standardized operation procedures, personnel training and performance appraisal.
If the above 6 points are done well, the maintenance accident of the mold can be generally reduced by 50%, and the production efficiency of the enterprise is also greatly improved.